Printable of ccna wireless 200 355 dumps training materials and questions pool for Cisco certification for IT examinee, Real Success Guaranteed with Updated ccna wireless 200 355 pdf dumps vce Materials. 100% PASS WIFUND Implementing Cisco Wireless Network Fundamentals exam Today!
If you would certainly such as to recognize more concerning 200-355 exam, call us or merely visit us at our internet 2PASSEASY.COM site.
P.S. Printable 200-355 questions pool are available on Google Drive, GET MORE: https://drive.google.com/open?id=1M81UajB7VS49cNb07P1yIJ6jhm26_B-2
New Cisco 200-355 Exam Dumps Collection (Question 1 - Question 10)
Question No: 1
A network engineer requires an antenna for a point-to-point bridge with at least 20 dBi of gain. Which antenna is appropriate for the task?
C. parabolic dish
E. internal omnidirectional
Question No: 2
You have a lightweight AP that has been moved to a new subnet and has become stranded because DNS and DHCP servers are unavailable. The AP cannot connect to the controller.
When connected to the console port, which three minimum parameters must you configure? (Choose three.)
A. AP IP address
B. controller name
C. AP hostname
D. default gateway IP address
E. controller IP address
F. username and password
Question No: 3
Which of the following are three functions of Cisco RRM? (Choose three.)
B. intercontroller roaming
C. dynamic channel assignment
D. intracontroller roaming
E. coverage hole detection
Question No: 4
What is an interferer that an engineer may see in Cisco CleanAir?
A. microwave ovens
B. rogue APs
C. malicious clients
D. co-channel interference
Question No: 5
Refer to the exhibit. A customer is using central web authentication with a Cisco 5508 Wireless Controller and Cisco Identity Services Engine. An error occurs when wireless clients are redirected to the hosted splash page. What is causing the client error?
A. Secure Web Mode is disabled on the WLC.
B. OCSP is disabled on the WLC.
C. Management Via Dynamic Interface is disabled on the WLC.
D. Ethernet Multicast Forwarding is enabled on the WLC.
Question No: 6
The AP is unable to join the WLC. What switch configuration will correct this problem?
A. interface vlanl
ip helper-address 10.10.10.10
B. interface vlan20
ip helper-address 10.10.10.10
C. ipdhcp pool vlanl
option 43 ascii '10.10.10.10'
D. ip dhcp pool vlan20 option 43 ascii '10.10.10.10'
E. ipdhcp pool vlanl
option 43 hex f1040a0a0a0a
F. ip dhcp pool vlan20 option 43 hex f1040a0a0a0a
Question No: 7
What are the three primary functions of the Cisco Unified Wireless LWAPP architecture? (Choose three.)
A. control and management of the CAPWAP
B. tunneling of VPN clients over the WAN
C. tunneling of WLAN client traffic to the WLC
D. collection of 802.1Q trunks
E. collection of 802.11 data for management
F. control and management of VTP
Question No: 8
What does RF determine?
A. cycle pattern size
B. how often a wave occurs
C. signal size
D. quantity of energy injected in a signal
Question No: 9
Which device divides a signal between two antennas?
B. lightening arrestor
Question No: 10
Following the deployment of a wireless network for data and voice services, an engineer is to validate the coverage. Which type of survey is required to ensure coverage?
Recommend!! Get the Printable 200-355 dumps in VCE and PDF From Dumpscollection, Welcome to download: http://www.dumpscollection.net/dumps/200-355/ (New 489 Q&As Version)